After My Pressure Seal Forms Are Printed On My Laser Printer, The Forms Tend To Curl Slightly. Will This Be A Problem For The Pressure Sealing Machine?

Yes, if your pressure seal form is curled from the heat of your printer or from the humidity of your office, the form may not feed properly into the pressure seal machine. The best way to test for form curls or waviness is to place 10 or so forms taken directly from the printer and create a pile on a table top. Then step back a few feet and look at the pile for curling or waviness. If you see either symptom, then you will need to manually roll back the curled corners in the stack of printed forms before placing them in the pressure seal machine feed table. If manually adjusting the curl of the forms does not resolve a feeding issue, contact your dealer or Paitec USA for further suggestions.